Service Details

  • Home
  • Service Details

China factory Check:


For factory QC checks, normally it means product QC check inspections before shipment - a quality QC preshipment inspection to make sure the quality level of the shipment is within acceptable limits, and all the packing info is correct, all the test results are acceptable. It can below be referred to a Factory Audit we have:

If it is a onsite product QC check inspection, the checklist will normally be something like below:

  • Product specs, and special requirements check
  • Labels, markings, logos & barcodes quality check
  • On-site safety, regulation & function testing
  • Quantity & assortment verifying
  • Packaging, safety and drop tests onsite
  • Measurements & sizes check
  • Aesthetic, visual defects, workmanship, surface and function inspection
China factory Check

Please find below for an onsite test list for ceramic knife in a typical preshipment inspection:

CHECK LIST COMMENTS RESULT
Visual inspection: do not allow the bending, flaw, crack, spots, scratches, wavy lines, etc
1. 陶瓷刀外观检验:不允许弯曲,瑕疵,裂纹,斑点,划伤,波浪纹等
PASSED 
Dimensional inspection: check the thickness of the blade and blade width (generally 3 to 4 inches of 8 mm, 9 mm 5 to 7 inches) and the degree of finish of the blade
2. 尺寸检测:测量刀片的厚度和大刃宽度(一般3-4寸 8mm,5-7寸9mm)和小刃的完度
PASSED 
Sharpness test: use A4 paper test
3. 锋利度测试:使用A4纸测试
N/A 
Blade volume density test: Density scale
4. 刀片的体积密度测试:密度天秤
FAILED
Red absorption test: will be 5pcs dry product knife put in the tray and add a small amount of red ink (did cover blade can soak 5-10 minutes, 
5. 吸红测试:将5把干燥的成品刀,放于托盘,加入少量红墨水(覆盖过刀片即可)浸泡5-10分钟,取出清洗干净后检查有无吸红现象
PASSED
Pressure test;
6. 压力测试
PASSED
Hardness testing: HRA80-95
7. 硬度测试:HRA80-95
PASSED
Bending strength test:
8. 刀具抗弯强度测试
PASSED

3rd party preshipment products goods onsite inline final Random AQL PSI TPI FRI DUPRO third party on-site in-line pre-shipment QA QC quality control assurance inspection services in India Vietnam Thailand Malaysia Bangladesh Taiwan.

 

Menu
x