The third party product quality QC check for fabric on-site preshipment FRI inspetions will usually us the 4 point system for fabric QC inspections (or 10 point stystem) to determine if the quality level, and will perform the onsite QC check inspections as follows:

Rub test
Thread ends
Packaging, labels and markings
Stitches
Fabric defects checking
Customer's specs
Foreign objects like broken pins, human hairs
Color differences and shifting
Stain, mould, odor and insects
Special requirements & on-site testing
Measurements

Most of the fabric onsite quality checks are Final Random Inspections, but we can also do if needed:

An example checklist of fabric onsite quality QC inspections FYI.

CHECK LIST	COMMENTS	RESULT
D1. Fabric Width Client’s Usable Width： - excluding selvedges Less than the specification is not acceptable.	Description: Usable width checking	PASSED
D2.Fabric Length of Roll Measured fabric length by a counter meter which set up on the fabric inspection machine to compare with roll ticket and packing list. Tolerance: must be within -2% against roll ticket	Refer to below MEASUREMENT TABLE - Actual Finding	PASSED
D3.Bowing and Skewing l Measure skewing / bowing by way of “drawing weft yarn” or “tearing” or their combining, depending on product characteristic. A= Variation of weft, B = Fabric overall width Please calculate A/B=? l Tolerance: - 2.5% of overall width for Y/D or Printing 3.0% of overall width for solid color	A/B=0%	N/A
D4.Color Shading Checking Within the Roll: D4.1 Color consistency check (in Width): Cut a swatch of about 20 cm along the width from the beginning, check if there is any color shading of side to side / side to center on the beginning /middle /ending area. Tolerance: Less than grey scale 4-5 is not accepted D4.2 Color consistency check (in length): Use above cut swatch, check 3 times per roll to see if there is any color shading of beginning to ending. Tolerance: Less than grey scale 4-5 is not accepted.		FAILED
D5.Color Shading Checking Between Pieces to Pieces: Check color consistency between Pieces and Pieces (i.e. lot shading). Tolerance: Color shade difference between pieces to pieces less than grey scale 4-5 is not acceptable.		PASSED
D6.Rub test / color fastness test: Use a white cotton cloth to rub the fabric. Rubbing shall be done on all the samples cut, with both a dry and a wet cloth. Expected result: l No color transfer worse than 4 on a grey scale (between the original white cloth and the colored one) for dry test l -No color transfer worse than 3-4 on a grey scale (between the original white cloth and the colored one) reference scale for wet test-must be as our technical sketches sent to you.-		PASSED
D7. Fabric Width Splice: -The minimum splice length for all fabrics is 30 yards/27 meters or a maximum allowance is three splices per 100 linear yards/meters unless special requirement that stated in the booking. ---------		PASSED

3rd party preshipment products goods factory onsite inline final Random AQL PSI TPI FRI DUPRO third party on-site in-line pre-shipment QA check quality control assurance services in China India Vietnam Thailand Malaysia Bangladesh Taiwan.

Service Details

Fabric QC inspection:

Menu